Techtronik.pl Serwis : Software, hardware, diagnoza, naprawa

spokoszeroko · Wysłany: 01 Mar 2009 20:06 **W510 - po s.locku nie podświetla LCD**

Witam! W trakcie zdejmowania s.l. z tej Motoroli Smart-Clipem wyskakiwal mi błąd nonstop przy wysyłaniu Boota więc myślę zrobię to kodem. Ale cóż to po złożeniu??? Nie ma podświetlania wyświetlacza!!! Pewnie coś zwarłem nie wiedząc o tym ale TP napeno miałem dobry. Motka trochę się grzeje. Czy ktoś coś wie na temat takiej usterki?
Dziękuję i pozdrawiam.

piratten · Wysłany: 01 Mar 2009 21:46

Kłania się umiejętność czytania... -> http://www.smart-clip.com/support.php

Cytat:

Prepare Smart TestPointArgon: K1s, K3, V1100, V3re (V3 EDGE, V3_06), V3re (boot v. 0C.F4), V3xx, V3xx Cingular (North America), V6maxx, V9, Foma M702iG, Foma M702iS.

LTE2_ROM4: L9, L72, U3, W5, W490, W510

Connect powered ON handset to PC via Smart-Clip (phone > USB cable > Smart-Clip > LPT cable > PC).
Connect S-Card to PC USB port.
Connect power supply to Smart-Clip and power on the handset.
Launch SmartMoto.
Choose "Smart-Clip USB port" in phone connection window.
Press "Search". The software should perform the following steps:
SmartMoto detects S-Card;
SmartMoto detects Smart-Clip;
SmartMoto detects the handset and reads all phone information.
Log to bookmark "Prepare"
Select an appropriate model from the list.
Mark "Unlock automatically" and press "Prepare Smart TestPoint" button.
Prepare operation is in progress. The handset gets reloaded, backup of firmware is saved.
SmartMoto pops up the message requiring Smart TestPoint cable to be connected. Please perform the following:
Disconnect the handset and dismantle it
Please ensure that LCD is disconnected from the board!!!
Connect Smart TestPoint cable to the port RJ45 on Smart-Clip
Connect data cable to the phone
Connect battery hook to the positive (+) battery contact on PCB
Connect needle A to the primary TestPoint A, hold it until the software informs that it can be disconnected and press OK in SmartMoto.
The handset should be detected with boot version 0.00.
Unlock procedure continues.
Disconnect TP needle when SmartMoto informs to do so.
If the option "Unlock automatically" was marked – the handset becomes unlocked. If the option was not selected then the handset can be served for Flash, Repair PDS, Unlock or Backup purposes.
NOTE. W490/W510 and Foma M702iG schematic contains 2 TestPoints, A (primary) and B (secondary). In case if unlock fails using single TestPoint A, please perform the process, using both TestPoints simultaneously (connect needle A to TP A and needle B to TP B).

szukałem ale nie mogłem znaleźć rozwiązania...